Digital Systems DSF22 - Terminal Control Register; Restarts Terminal; Restarts GSM Module

DSF22 UNIQUE MONITORING TERMINAL
38
INSTALLATION AND SETUP GUIDE
STATUS Terminal control register
Description
This command requests contents of terminal control register
Options
Parameter is read only.
Used values
UNS – Number of unsent events in terminal’s memory
GPRS – Number of unsuccessful GPRS connections
RES - Number of terminal power resets
MEM – Number of data memory faults
GPS – Number of GPS module restarts
POW- Terminal power supply voltage
AIN – External Analog input voltage
IGN – Status of Ignition (0-off, 1-on)
IN1 – Status of digital input (0-off, 1-on)
FIX – GPS signal quality
Default value
Example
To read parameter:
GET STATUS
Response from device:
UNS:00004, GPRS:000, RES:002, MEM:000, GPS:002, POW:12.09V,
AIN:00.01V, IGN:0, IN1:0, FIX: 3
RESET Restarts terminal
Description
This command performs full restart (reboot) of terminal.
Options
Parameter is write only.
Used values
Default value
Example
To perform command:
SET RESET
Response from device:
(no response from device)
RSTGSM Restarts GSM module
Description
This command performs full restart of GSM module.
Options
Parameter is write only.
Used values
Default value
Example
To perform command:
SET RSTGSM
Response from device:
(no response from device)