Digital Systems DSF22 - P28 GPS Signal Interruption SMS Alert; P30 Digital Output 1

DSF22 UNIQUE MONITORING TERMINAL
25
INSTALLATION AND SETUP GUIDE
P28 GPS signal interruption SMS alert
Description
This parameter enables/disables SMS alert sending in case if GPS signal has
been interrupted.
Options
Parameter can be read and modified.
Used values
0 – GPS signal interruption SMS alert disabled
1 – GPS signal interruption SMS alert enabled
Default value
0
Comments
Example
To read parameter:
GET P28
To set parameter:
SET P28 1
Response from device:
P28: 1
P30 Digital output 1
Description
This parameter defines condition of digital output Nr1. It is useful in cases
when some of vehicle’s equipment (autonomous heating system, lights,
etc.) must be activated remotely.
Options
Parameter can be read and modified.
Used values
0 – Digital output deactivated
1 – Digital output activated
Default value
0
Comments
In case of terminal power loss or restart, this parameter will be set to 0
Example
To read parameter:
GET P30
To set parameter:
SET P30 1
Response from device:
P30: 1