4 - 4 How Do I ...?
DigiGate-700
for Windows
™ ®
1. Click on the
Unit Setup
tab of the
Setup Menu
, then Click on the
Add Units
button.
2. To add a consecutively numbered group of units, Select the
Starting Unit Number
field and
type in the first unit number in the group.
3. Select the
Ending Unit Number
field and type in the last unit number in the group.
4. If you do not have Required Fields for this group, Click on the
OK
button. The
Add Unit
Progress
bar will reflect the units being added. Otherwise continue with the following steps.
Add Units
Unit Numbers
Unit Size Information
Misc Unit Information
1. If you selected
Unit Size
as a required field, Click on the
Size
tab and Select the proper size
description from the
Size
list box. The
Square Feet
,
Height
, and
Price
fields will display
the information you entered earlier in the set up procedure.
1. If you selected
Unit Type
,
Door Type
,
Floors
, or
Inside/Outside
as required fields,
Click on the
Misc
tab and Select the proper descriptions from the appropriate list boxes. If
necessary, Click on the proper
Inside
or
Outside
selection.
Unit Features
Door Alarm Options
1. If you selected
Feature 1
,
Feature 2
,
or
Feature 3
as Required Fields, Click on the
Features
tab and Select the proper features from the appropriate list boxes.
1. If all of the units in the group you are adding have individual Door Alarms, Click on the
Door
Alarm
tab.
2. Select the
Mux
list box and from the list of boards, Select the correct board.
3. After a Mux board has been selected, the
Slot
field will be activated. Until the board
selection, this field is deactivated and cannot be selected. Use the Up or Down arrows at the
right side of the box to increase or decrease the number in the
Slot
field. This number is the
starting number for the group of units you are adding.
4. Select the
Alarm Zone
list box and from the list of boards, Select the correct zone for this
unit. Normally there is only one Zone “Door Alarms.”
5. If you are loading multiple units that have slot numbers in some sequence respective to the
unit numbers, select one of the choices {
Increase | Decrease
} and the value to increment
BY
in the
Auto Slot Loading Options
area.
6. Click
OK
to add the units or
Cancel
to abandon the operation.
NOTE: See Page 2-37 in Chapter 2.
To Next Page
Need help?
General
