OPERATIONAL MANUAL
- 18 - D03S THERMAL TRANSFER OVERPRINTER
Out dia. 53.05mm tracking wheel
Standard DK Encoder is a DB9 connector, can be insert to printer.
2. Air Inlet:
D03 requires the compressed air 0.25Mpa~0.45Mpa
Set the air pressure by the followings:
1. Mount the air pressure regulator: the IN connects 6mm air tube and the OUT connects 4mm air
tube to join with the Air Inlet of printer.
2. The value on regulator should be between 0.25-0.45Mpa;
3. If not, pull out the knob, rotate clockwise to increase the pressure, or count-clockwise to decrease
the pressure into proper (green area).
To Next Page
Loading...