To Next Page
J
Jennifer ParkerSep 8, 2025
Why brake was not detected on Directed Control Unit?
- KKevin SnyderSep 8, 2025
The brakes were not detected, which prevents the system from shutting down the vehicle.
Why brake was not detected on Directed Control Unit?
The brakes were not detected, which prevents the system from shutting down the vehicle.
What to do if Directed DIRECTWIRE DIRECTECHS 933.TL14 transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if ISO 1 is not detected on Directed Automobile Electronics?
If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if my Directed Remote Starter shows CAN1 not detected?
If your Directed Remote Starter shows a 'CAN1 not detected' error, check the connections of the CAN1 Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If the installation doesn't need this connection, you can skip the step by pressing the programming button 5 times.
What does it mean if OBDII feature is not supported in Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories?
If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if Directed DIRECTWIRE DIRECTECHS 933.TL14 CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if MUX is not detected on Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
Why Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories says 'OBDII feature not supported'?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if there is a bypass processing error on Directed Control Unit?
Reset the module and try again. If the condition persists, please contact Technical Support.
What does it mean when my Directed Automobile Accessories says 'MUX not detected'?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
General| Brand | Directed |
|---|---|
| Model | DIRECTWIRE DIRECTECHS 933.TL14 |
| Category | Automobile Accessories |
| Language | English |
