What to do if ISO 1 is not detected on Directed Automobile Electronics?
If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories says 'OBDII feature not supported'?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories waiting to begin the programming sequence?
Ensure the correct programming procedure is being followed.
What to do if my Directed Remote Starter shows CAN1 not detected?
If your Directed Remote Starter shows a 'CAN1 not detected' error, check the connections of the CAN1 Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If the installation doesn't need this connection, you can skip the step by pressing the programming button 5 times.
How to troubleshoot Directed Control Unit when module has no power?
Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective.
What causes a bypass processing error in Directed DIRECTWIRE DIRECTECHS 933.TL14?
Reset the module and try again. If the condition persists, please contact Technical Support.
What does PTS shutdown error mean on Directed Control Unit?
The PTS output from the module was not activated due to safety protection.
Why was Runsafe not disabled on my Directed Remote Starter?
If the Runsafe feature wasn't disabled on your Directed Remote Starter, it's likely because no UNLOCK command was received before opening the door, or the 45-second timer expired in takeover mode.
What to do if Directed Automobile Accessories module has no power?
First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
What to do if CAN1 is not detected on Directed DIRECTWIRE DIRECTECHS 933.TL14?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | DIRECTWIRE DIRECTECHS 933.TL14 |
| Category | Automobile Accessories |
| Language | English |
To Next Page