What to do if my Directed Remote Starter shows CAN1 not detected?
If your Directed Remote Starter shows a 'CAN1 not detected' error, check the connections of the CAN1 Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If the installation doesn't need this connection, you can skip the step by pressing the programming button 5 times.
What to do if Directed DIRECTWIRE DIRECTECHS 933.TL14 CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if ISO 1 is not detected in Directed Automobile Accessories?
If the ISO 1 is not detected in your Directed Automobile Accessories because the Yellow/Black wire did not detect the expected signal, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
What to do if my Directed Remote Starter shows that ISO 2 is not detected?
The Orange/Black wire didn't detect the expected signal. Check the connections.
What does it mean 'Bypass and CAN were skipped' in Directed Automobile Accessories?
This means that the programming button was pressed 5 times to skip bypass and 5 times to skip the CAN.
What to do if my Directed Automobile Accessories module has no power?
First, check that the D2D harness is connected and that there is 12 Volts between the red and black wires. If 12 Volts is present, it is possible that the module is defective.
What to do if Directed Automobile Accessories ISO 1 not detected?
If the Yellow/Black wire did not detect the expected signal, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What does it mean if Directed DIRECTWIRE DIRECTECHS 933.TL14 Automobile Accessories PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
Why is Directed Automobile Accessories showing 'Speed was detected'?
The vehicle was detected as moving, which prevents the system from shutting it down.
What to do if Directed DIRECTWIRE DIRECTECHS 933.TL14 transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
General| Brand | Directed |
|---|---|
| Model | DIRECTWIRE DIRECTECHS 933.TL14 |
| Category | Automobile Accessories |
| Language | English |
To Next Page