Ditch Witch C16 Series - Drive

Drive - 40 C16x/C24x/C30x Operator’s Manual
Start
Start
1. Ensure all controls are in neutral.
2. If necessary, use choke control to start cold engine.
3. Move throttle to 1/4 open.
4. Turn ignition switch to START position to crank engine.
5. Release key when engine starts.
6. Run engine at half throttle or less for five minutes before operating trencher.
7. During warm-up, do a check of all controls. Ensure they operate correctly.
Fire or explosion possible.
To help avoid injury: Do not use starter fluid.
IMPORTANT: If engine does not start, turn ignition switch to OFF position and check for fuel
blockage or electrical system problems.
Incorrect control function can cause death or serious
injury.
To help avoid injury:
If controls do not operate as given in instructions:
• Shut down machine immediately.
• Have machine repaired.
EMERGENCY SHUTDOWN: Release controls and turn ignition switch to OFF position.