C16x/C24x/C30x Operator’s Manual Trench - 55
Finish Job
Remove Objects from Digging Chain
If object becomes lodged in chain:
1. Move attachment speed/direction control to neutral.
2. Slightly raise boom.
3. Reverse chain direction.
If object stays lodged in chain:
1. Shut down machine. See “Shut Down” on page 43.
2. Engage parking pin in parking position.
3. Carefully remove object by hand.
Finish Job
1. When trench is complete, release speed/direction controls.
2. Move throttle to half open.
3. Pull boom control to raise digging boom to top of trench.
4. Release digging chain control.
5. Install backfill blade in work position for backfilling.
6. When backfilling is completed, position blade in upright “stowed” position for transporting, keeping
digging boom low to ground. See “Backfill Blade” on page 75.
7. Drive away from trench.
8. Shut down machine. See “Shut Down” page 41.
Moving digging teeth can kill. Trench cave-in can
cause you to fall. Stay away.
To help avoid injury:
• Wait until digging chain is completely stopped.
• Wear safety gloves.
6ft/2m
To Next Page
Loading...
Need help?
General
