Conduct a Bore - 70 JT5 Operator’s Manual
Prime Drilling Fluid Pump
CMW
®
Prime Drilling Fluid Pump
Prime drilling fluid pump each time tank is changed. To prime the pump:
1. Fill drilling fluid hose and connect hose to unit.
2. Operate mixing/transfer pump at full speed for 1 - 3 minutes to discharge air from system.
3. Return mixing/transfer pump to normal operating speed and continue the bore.
4. If drilling fluid pressure surges are observed, repeat step 2.
Read operator’s manual. Know how to use all controls.
Your safety is at stake. 273-475.
To help avoid injury: Failure to prime the drilling fluid pump will cause
flow fluctuations, which will make it difficult to control the washwand.
Pressurized fluid or air could pierce skin and cause
severe injury. Refer to operator’s manual for proper use. 270-6035
To Next Page
Loading...
