Conduct a Bore - 72 JT5 Operator’s Manual
Clamp Pipe
CMW
®
Clamp Pipe
Clamp on pipe when joint is centered between
wrenches (1 and 2). Always clamp on the larger
diameter areas on either side of the tool joint face.
Turning shaft can kill you or crush arm or leg. Stay away.
To help avoid injury: Clamping anywhere else on the pipe will weaken
the pipe. Pipe can later break, even when operating under normal loads.
Read operator’s manual. Know how to use all controls.
Your safety is at stake. 273-475
To help avoid injury: Ensure that any downhole tool or pipe in tool joint vises is attached to spindle or
removed before transport. Wrenches can open after engine shutdown.
To Next Page
Loading...
