JT5 Operator’s Manual Conduct a Bore - 81
Assemble Backream String
CMW
®
1. Select backreaming devices. See “Backreamers” on page 104.
2. Determine fluid rate requirements and install appropriate nozzles to provide sufficient flow. See
“Backream Fluid Requirements” on page 105 and “Nozzles” on page 102.
3. Attach backreamer to backream beacon housing if tracking backream.
4. Install beacon, following beacon instructions for:
• battery replacement
• beacon positioning
5. Install beacon housing lid. See “Beacon Housings” on page 103.
6. Follow beacon instructions to check beacon operation.
7. Follow tracker instructions to calibrate beacon.
8. Connect EZ-Connect joint or use quick wrench to attach backreamer/beacon housing assembly to
transition sub. See “Quick Wrench” on page 107.
9. Attach pullback devices or product to end of backreamer/beacon housing assembly.
To Next Page
Loading...
