RT45 Operator’s Manual Plow - 107
Setup
Position Tractor
1. Fasten and adjust seat belt.
2. Start tractor. See page 72 for start-up procedures.
3. Drive to starting point. Move in line with planned trench. See page 74 for driving procedures.
4. Set parking brake.
5. Lower backfill blade, if equipped.
6. Lower plow to starting point of trench.
7. Turn ignition switch to STOP.
Attach Product
Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
IMPORTANT: If material must be at a constant depth, dig starting and target trenches.
To Next Page
Loading...
