RT45 Operator’s Manual Drill - 119
Operate
Install Product
To install product, pull it through the bore after drilling or final pass of backreaming.
1. Install applicable swivel (2) to drill string
(1) or reamer. Ensure swivel functions
correctly.
2. Use shackle (3) to attach pipe pulling
adapter (4) or pulling grip (5) to swivel.
3. Attach material to pipe pulling adapter or
pulling grip.
4. Set engine to low throttle.
5. Slowly back up machine. If there is a
blockage, begin counterclockwise
rotation.
6. When product exits approach trench, stop machine immediately.
Rotating shaft will cause death or serious injury. Stay
away.
To help avoid injury: Ensure no one is in target trench or near product
being installed. If swivel malfunctions, material can rotate.
IMPORTANT: If length of rod outside
the bore reaches 30’ (9 m), remove
rod section. See “Remove Rod” on
page 120.
To Next Page
Loading...
