Plow - 110 RT45 Operator’s Manual
Finish Job
Finish Job
1. When installation is complete with vibrator running, raise plow to ground level while reducing vibrator
speed.
2. Move attachment speed/direction control to neutral.
3. Set parking brake.
4. Lower backfill blade, if equipped.
5. Turn ignition switch to STOP and remove product from plow.
6. Turn ignition switch to ON.
7. Swing plow to center position and engage swing lock and stow lock.
8. Release parking brake.
9. Drive a short distance away from work site.
10. Shut down tractor. See page 75 for proper shutdown procedures.
NOTICE: Do not operate vibrator when plow is out of the ground.
To Next Page
Loading...
