RT45 Operator’s Manual Drill - 121
Operate
Reconnect Drill String
1. Start engine and set to low throttle.
2. Slowly move machine forward until attached rod section and drill string are about 1’ (30 cm) apart.
3. Have helper lightly hold attached rod section and drill string so that they are aligned.
4. Rotate drilling attachment to align slip latches of new rod section and drill string.
5. Move unit forward slowly. As soon as new rod section engages drill string, have helper move hands
clear.
6. Slightly move forward until the slip latch connection is correctly latched.
Pinch point. Crushing will cause serious injury.
To help avoid injury:
• Keep hands at least 6” (15 cm) from ends of rod section and drill string.
• Support rods from underneath with open palms. Do not grip rods.
To Next Page
Loading...
