Complete the Job - 140 RT45 Operator’s Manual
Restore Jobsite
Restore Jobsite
After product is installed, return spoils to the
trench with backfill blade.
Backfilling
1. Position unit at end of trench, several feet
from spoils. Aim tractor at outer edge of
spoils.
2. Adjust backfill blade to fit land contour.
3. Move outer edge of spoils toward trench.
Take two or more passes at spoils rather
than moving all spoils at once.
4. Repeat on other side of trench, if
necessary.
5. Engage float and make final pass in
reverse over trench.
Rinse Equipment
• Wash saw bits and mounting blocks with high pressure water before parking unit overnight.
• Spray water onto equipment to remove dirt and mud.
Stow Tools
Make sure all tools and accessories are loaded and properly secured on trailer.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe
down instead.
To Next Page
Loading...
Need help?
General
