revision: 1
FlexxPump 125 B
User Manual
18
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
6. Operation and settings
6.1 General information
What you should know about operating and setting the FlexxPump 125 B:
FlexxPump 125 B is designed as a single point lubricator for one lubrication point.
However, depending on the specific application, FlexxPump 125 B can also supply a
limited number of lubrication points reliably and cleanly with lubricant. Accessories from
the manufacturer can be connected to the FlexxPump 125 B. If necessary, changes
must be made to the FlexxPump 125 B settings to ensure safe and reliable operation.
The FlexxPump 125 B is a cycle-controlled lubricant dispenser which operates
autonomously and time-based via the integrated microelectronics.
The FlexxPump 125 B cyclically delivers a dened quantity of lubricant from the
cartridge to the outlet. Two operating modes can be selected. The Hour-Mode -h-
allows setting the number of cycles (c) within a dispensing time (h) in hours. The cycles
(c) are evenly distributed over the dispensing time. Dispensing times (h) between
1...24 hour(s) and cycles (c) between 1...10 can be set.
The Empty-Time-Mode Et allows the emptying time of the cartridge to be set in
months. Emptying times between 1...24 month(s) can be set.
The disposable interchangeable cartridge with 125ml lubricant guarantees a
controlled and constant quality of the lubricant and is lled without air bubble inclusions.
The FlexxPump 125 B allows a high supply security of the lubrication point and
prevents failures. The FlexxPump 125 B in its present version is designed for the
lubricant grease and oil.
The FlexxPump 125 B cannot be used in the present version without a lubricant
cartridge and suitable battery. Both can - depending on the version ordered - already
be included in the scope of delivery and may already be connected and installed in the
FlexxPump 125 B.
For operation under normal operating conditions, FlexxPump 125 B can be operated
with an alkaline battery, for increased requirements with the more powerful lithium
battery.
The respective conditiones of the FlexxPump 125 B can be seen in the LCD, which
additionally enables the optical recognition of the condition by means of coloured LEDs.
If you have any questions about your application and the correct settings for
FlexxPump 125 B, please contact the manufacturer (chapter I.II).
To Next Page
Loading...
