DLS FlexxPump 125 B - Visual Check; Cleaning; Recommissioning after Maintenance

revision: 1
FlexxPump 125 B
User Manual
43
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
 Clean the FlexxPump 125 B from dirt using suitable cleaning agents (e.g. absorbent
towels, cloths).
NOTICE
Compressed air can damage the seals of the FlexxPump 125 B
as well as transport dirt and foreign bodies into the FlexxPump
125 B or the lubricant.
§ Do not use compressed air to clean the FlexxPump 125 B.
7.1.1 Visual check
 Reinstall all safety devices and make sure that no tools remain in the danger area.
 Check that the FlexxPump 125 B is turned on.
 Carry out a "Quick Check" (test run) using the RUN command (section 6.3.7).
 Check the entire lubrication system (FlexxPump 125 B and any connected
accessories including tubes and distributors) for external damage (e.g. loose or
loosened tubes) by a thorough and conscientious visual inspection.
 Check the condition of the lubrication point for correct supply of lubricant.
 Replace damaged or defective parts immediately to ensure permanent lubrication.
 Check the filling level of the cartridge on the FlexxPump 125 B.
 Check possible error messages on the FlexxPump 125 B and remedy the causes
accordingly.
7.1.2 Cleaning
7.1.3 Recommissioning after maintenance