revision: 1
FlexxPump 125 B
User Manual
35
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
6.3.8 PRO-Menu operating mode Hour-Mode -h-
The PRO-Menu allows you to change the settings of the FlexxPump 125 B's dispensing
behavior. If you are in operating mode Hour-Mode -h-, you can change the dispensing
time h as well as the number of cycles c (number of strokes). In principle, during the
dispensing time h, the FlexxPump 125 B executes exactly the number of strokes c
(each 0.16 cm³) specied in the number of cycles c. The cycles c are evenly distributed
over the dispensing time h.
There is no fault or error at FlexxPump 125 B.
In the PRO menu, the rst step is to set the dispensing time h and afterwards the
number of cycles c; direct access to the number of cycles c is not possible.
Remove the activation and programming key from the bottom of FlexxPump 125 B
and place it on the action area. Hold the activation and programming key on the action
surface. Leave the activation and programming key on the action area until PRO is
displayed in the LCD.
Remove the activation and programming key from the action area as long as PRO is
displayed in the LCD.
Ü The LCD ashes together with the green LED twice. The LCD rst displays the
currently set value of the dispensing time h (h
is
). Now you have the possibility to change
the values of the dispensing time h.
To Next Page
Loading...
