DLS FlexxPump 125 B - Lubricants; Tube Lengths

revision: 1
FlexxPump 125 B
User Manual
49
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
8.1 Lubricants
In principle, the recommendation is to install the FlexxPump 125 B as close as possible
to the consumer (lubrication point). Ideally, this should be done directly at or on the
lubrication point. In cases where this is not possible due to the installation space or for
reasons of reachability or accessibility, tubes can also be used between the FlexxPump
125 B and the lubrication point (or distributor).
If the case arises that you cannot mount the FlexxPump 125 B directly on or at the
lubrication point, contact the manufacturer to verify your application. The inuence
of temperature, the grease used, the hoses and accessories used does not allow a
general statement to be made about the possible hose length on the FlexxPump 125 B
8.2 Tube lengths
Only use lubricants approved by the manufacturer DLS Schmiersysteme GmbH in the
original cartridges developed and manufactured exclusively for FlexxPump 125 B.
NOTICE
The lubricant used in each case differs according to the
application. The respective designation can be found on the
label of the cartridge.

Further information on lubricants, documentation and safety data sheets can be
obtained directly from the manufacturer DLS Schmiersysteme GmbH.