8 Digital Monitoring Products, Inc. | Troubleshooting Guide
ADDRESSING DEVICES
Setting Address on 7000 Series keypads
1
Press and hold the CMD and Back Arrow keys until SET BRIGHTNESS appears on display�
2
Enter 3577 (INST) + CMD�
3
Press key under KPD OPT (Keypad Options)�
4
Keypad displays CURRENT KEYPAD ADDRESS: xx (xx = address 01-16)�
5
Press any top row select key�
6
Enter desired address� (Do not enter leading zeroes�) Press CMD to scroll to next option�
7
KEYPAD MODE: SUP UNSUP: To choose Supervised or Unsupervised operation, press select key under SUP
or UNSUP� Press CMD� (Keypads should be left Supervised unless specifically needing to be Unsupervised�)
8
DEFAULT KEYPAD MSG: Press select key, enter message to be displayed on top row of display, and then
press CMD�
9
ARM PANIC KEYS: PN EM FI: Press select keys below each to enable� When enabled, each will appear as
*PN *EM *FI (report as Zones: PN=19, EM=29, FI=39)� Press CMD�
10
ACTIVATE ZONE 2 BYPASS: NO -: Used with 7073 and 7873 keypads for Soft Shunt function� Press CMD�
11
RELOCK ON ZONE 2 CHANGE: NO -: Used with above keypads for relocking a door when the zone returns
to a normal state, instead of wating for the strike time to expire�
12
ACTIVATE ZONE 3 REX: NO –: Also used with above keypads for REX function� Press CMD�
13
NO OF USER CODE DIGITS: 5 –: Press top row key, press 4, and then press CMD for Home/Away or other
systems that require 4 digit codes� Press CMD�
14
ALL? NO YES DELAY: 2 –: This option is for use in an Area Mode system� When arming, ALL? YES NO is
displayed on the keypad� When NO or YES is not selected before this delay (1 to 9 seconds) expires, the
keypad automatically selects YES� Enter zero to disable this feature� Press the CMD key�
15
CARD OPTIONS DMP -: Sets the card format used by the reader in the keypad� Press select key for custom
option�
16
REQUIRE SITE CODE: NO -: Determines if an access credential’s site code will be required�
17
NO COMM WITH PNL OFF -: Defines the state of the door if the keypad loses communication with the
panel� Press select key for more options�
18
SYSTEM OPTIONS: AREA -: (Graphic touchscreen keypads only) Set to the same system type that is set in
System Options in the panel’s programming menu for proper shield operation�
19
DEALER LOGO ADD DELETE -: (Graphic touchscreen keypads only) Load or update the logo displayed on
the main screen�
20
DEALER INFO ADD DELETE -: (Graphic touchscreen keypads only) Load or update the contact information
stored in the keypad�
21
KPD OPT KPD DIAG STOP –: Press select key under STOP�
To Next Page
Loading...