28 Digital Monitoring Products, Inc. | Troubleshooting Guide
X-BUS
Press any select key to display the firmware version
of a connected 1100 Series Wireless Receiver� This is
useful in testing communication between the panel
and the wireless receiver�
An 1100X or 1100XH Wireless Receiver must be
connected to the X-Bus header, and a house code
between 1 and 50 must be set in System Options for
the panel to display this information�
MAC ADDRESS
Every node on a network has a MAC address� Think of
the MAC address as a ‘hard-coded’ serial number for a
piece of network equipment�
Computers, routers, network printers and the panel
all have a unique MAC address, which is used for
hardware identification�
Press any Select key to view the MAC (Media Access
Control) address for the panel’s built-in network
communicator�
Note: The MAC address is not the same as an
IP address� IP addresses are used for network
communication� MAC addresses are used for
hardware identification�
SERIAL NUMBER
Press any Select key to view the panel’s serial number�
Reference this serial number to find the panel serial
number needed for warranty and for Easyconnect or
Deal Admin�
LOADER VERSION
This display is for factory use only�
CURRENT FLASH
This display is for factory use only�
COMM STATUS
Press any Select key at the COMM STATUS display� The
keypad will display a prompt to enter a path number�
Enter the communication path number to test cellular
or network communication and IP programming�
CELL SIGNAL
Press any Select key to view the signal strength of the
connected cellular modem�
ACTIVATE CELL
This is an option only if the panel has a 263C or 265C
cellular modem� Press any Select key, and select YES
when prompted to start activation�
This is a separate step from submitting an activation
request to SecureCom, and should be performed after
the initial activation is successful�
PC PROGRAMMING
This allows the user to Remote Program the panel
using a 399 cable attached the LX5150 header�
Press any Select key, and the keypad will display
PROGRAMMING�
TEST Z-WAVE
Use this option to test panel communication with
Z-Wave devices� Displays results as the number of
successful tests over the number of total tests�
WI-FI SIGNAL
Press any select key to view the SSID (Network Name)
and the current signal strength�
STOP
Press any Select key at the STOP display to exit the
Diagnostics menu�
To Next Page
Loading...
Need help?
General