DOD CL96 - Page 18

Page 15 of 44
DOD Technologies, INC • 675 Industrial Dr. Bldg. A • Cary, IL 60013 • Phone (815) 788-5200 • Fax (815) 788-5300
DC-MAN-CL96Servicemanual
www.dodtec.com
Innovative Life Safety Systems & Services
96146
Output Module Offline
The PC cannot communicate with the
I/O modules
1. Refer to the I/O
Verification
Procedure
96147
Point Disabled Due to High
Background
A point has been disabled due to a high
background
1. Press Verify Optics
button in the Load
Tape screen
96153
Warning: PT Disabled, Check
Optic Block(Ref)
A point was disabled due to reference
fluctuations
1. Replace the optic
block
96154
Pyrolyzer Failure - Point Disabled
A single Pyrolyzer element has failed
1. Replace element
96101
No event file found for selected
date
The CL96 could not locate a log file for
the selected day.
None needed
96102
Starting new log file
New log file started
None needed
96103
Power On
CL96 was powered on
None needed
96106
Faults & Alarms Reset
Faults and alarms were reset.
None needed
96126
Optic Calibrated
Optic calibration was manually
performed.
None needed
96127
Flow Offsets Reset
Flow offset calibration was performed.
None needed
96128
Point configuration
updated/saved
Point Configuration was changed and
saved.
None needed
96129
Machine configuration
updated/saved
System Configuration was changed and
saved.
None needed
96132
Simulation Mode
Simulation Mode started.
None needed
96134
K Factor update
K Factor update
None needed
96135
Passwords updated
Passwords updated
None needed
96136
Multi-Point configuration change
Multi-Point configuration change.
None needed
96137
Previous machine settings
restored.
Previous machine settings restored.
None needed
96139
ChemLogic tape days counter
reset
ChemLogic tape days counter reset.
None needed
96141
PLC Connected
PLC Connected
None needed
96142
Optics Auto Adjusted
Optics Auto Adjusted
None needed
96143
Optic Point Needs Cleaning
Optic Point Needs Cleaning
1. Refer to the Optic
Cleaning Procedure.
96145
Optic Adjustment Suggested
Optic Adjustment Suggested
1. Refer to the Optic
Cleaning Procedure.
96150
Point Alarm Output Disable
Point Alarm Output Disable
None needed
96151
Point Output Disable Timer
Reset
Point Output Disable Timer Reset
None needed
96152
Optic Validation(Ref)
A point has an unstable reference value.
Replace the optic
block
96154
Established PLC Connection
Established PLC Connection
None needed
96155
Restarting PLC Connection
Restarting PLC Connection
None needed