EasyManuals Logo

Domino F720i User Manual

Default Icon
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
INSTALLATION INSTRUCTIONS
2-64 EPT031055 Issue 2 September 2017
Product Distance and Print Start - Ignore
Distance
With this special feature it is possible to set a minimum and maximum
distance between two products to mark.
Login as administrator and navigate to:
Home > Settings > Production Line Setup > Line Movement > Product
Distance
Setup the “Maximum Distance” and/or the “Print Start Ignore Distance” in
millimetres.
Both options are deactivated by setting the distance to 0.00 mm.
To activate one or both options enter a distance.
If “Maximum Distance” is exceeded by passing products between
two print start signals an error message is displayed: “Maximum print
to print distance exceed”. The error ID is 14. The system is not any
longer ready for printing.
If “Print Start Ignore Distance” is under-run by passing products
between two print start signals a warning message is displayed:
“Print start signal ignored”. The error ID is 15. The second print start
signal is ignored and does not lead to a print on the product. A
possible “Print Start while Printing” error is suppressed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Domino F720i and is the answer not in the manual?

Domino F720i Specifications

General IconGeneral
BrandDomino
ModelF720i
CategoryPrinter
LanguageEnglish

Related product manuals