INSTALLATION INSTRUCTIONS
2-16 EPT031055 Issue 2 September 2017
The F-Series laser marking system offers a DC beacon interface for 24V
Domino standard beacons with 4 colours.
Connector Type: IEC 60130-9 Type 5 way female
Mating Cable Connector (IP67 Types):
• Lumberg: 033205-1
Pin description
• Pin 1 BLUE - Blue Lamp +24V Output
• Pin 2 AMBER - Amber Lamp +24V Output
• Pin 3 GREEN - Green Lamp +24V Output
• Pin 4 RED - Red Lamp +24V Output
• Pin 5 GND - Floating Ground
Outputs
Voltage: 24V floating, max. current 170mA
The beacon indicators are in a solid state as described below:
• Green - printer is printing or ready to print.
• Red - there is a fault, printer has stopped.
• Amber - printer requires attention - a warning is displayed but printer is
printing.
• Blue - software loaded - printer is not ready
If there is a critical error the red and blue indicators are on.
If the LEDs directly on the laser (see Chapter 3 - Indicator lamps) are not
observable due to installation reasons a red LED has to be connected to
X2: Pin3 to show laser readiness or laser activity.
To Next Page
Loading...
Need help?
General
