DoorKing 4302 - Radio Receiver Mode and Programming; Check and Change Receiver Mode; Learn Master Transmitters; Erase All Receiver Memory

4302-067-G-2-21
28
3.5 Radio Receiver Continued
Change Receiver Mode - MicroPlus
®
or MicroClik
®
Check if Receiver is set for MicroPlus
®
or MicroClik
®
Mode
2. Press and hold Program Button until the Program LED flashes ONCE and receiver will BEEP once. Press and hold button again,
LED will flash and receiver will beep. Press and hold button a third time until LED continually flashes and beeps.
Note: If receiver does not emit a continuous beep after pressing the button 3 times, try repeating step 2 faster or slower until it does.
3. Turn power OFF, then back ON. Receiver will BEEP twice for MicroClik
®
mode (1B) or three times for MicroPlus
®
mode (1A).
1. Turn receiver’s power OFF then back ON.
2. Receiver will BEEP TWICE for MicroClik
®
mode. Receiver will BEEP THREE times for MicroPlus
®
mode (Factory Setting).
If you need to change the receiver’s mode, follow the steps below.
CAUTION: Changing an EXISTING programmed receiver from one mode to the other will erase ALL EXISTING MEMORY that has been
previously programmed in the receiver. This cannot be UNDONE.
OR
Learn Master Transmitters (Up to 4 Transmitters)
2. Press and hold Program Button until the Program LED flashes ONCE and receiver will BEEP once. Receiver is now in “Learn Mode” and
will flash and beep every second for 10 seconds.
3. Press the button on the master transmitter to be “Learned” within 10 seconds. Receiver will reset 10 second timer after each master
transmitter button has been pressed.
4. Press other master transmitter buttons to be learned, each within a 10 second time period.
5. After all desired master transmitters have been learned by the receiver (up to 4 total), wait for the receiver to time-out.
Note: Keep master transmitters is a secure place.
Up to 4 Master transmitters can be created to quickly program new transmitters in the future.
After programming is complete for a master transmitter’s button, when that desired button is pressed, it puts the receiver into “Learn Mode”
for that button. New transmitters can then be programmed in. Press each NEW transmitter’s desired button within a 10 sec. time period to
have receiver learn new transmitters. Wait for receiver to time out (10 sec) when finished.
Erase ALL Memory - This CANNOT be UNDONE
2. Press and hold Program Button until the Program LED flashes ONCE and receiver will BEEP once. Press and hold button again, LED will
flash and receiver will beep again. Press and hold button a third time, LED will flash and receiver will beep a third time.
3. The receiver will then emit a long flash and long beep indicating ALL memory, including master transmitters have been erased from
memory.
Note: If receiver does not emit a continuous beep after pressing the button 3 times, try repeating step 2 faster or slower until it does.
1
2
3
4
5
6
7
7
8
9
A
B
C
D
E
F
1. Turn the Programming Selector to “Position 7”.
1
2
3
4
5
6
7
8
9
A
B
B
C
D
E
F
1
2
3
4
5
6
7
8
9
A
B
C
C
D
E
F
1
2
3
4
5
6
7
8
9
A
A
B
C
D
E
F
1A. Turn the Programming Selector to “Position B” will change to MicroPlus
®
mode.
1B. Turn the Programming Selector to “Position C” will change to MicroClik
®
mode.
1. Turn the Programming Selector to Position A.
Continued on next page.