Doosan G424FE - Table 1. Fault List Definitions

G424F(FE) Service Manual Chapter 9. Advanced Diagnostics 251
Table 1. Fault List Definitions
FAULT DESCRIPTION
CODE
(MI04 CODE)
APP1AdaptHiMax
Learned full pedal end of APP1 sensor range higher than
expected
641
(64)
APP1AdaptHiMin Learned full pedal end of APP1 sensor range lowe 651
APP1AdaptLoMax than expected 661
APP1AdaptLoMin
Learned idle end of APP1 sensor range higher than
expected
631
(63)
APP1RangeHigh
Learned idle end of APP1 sensor range lower than
expected
621
(62)
APP1RangeLow
APP1 sensor voltage out of range high, normally set if the
APP1 signal has shorted to power or the ground for the
sensor has opened
611
(61)
APP2AdaptHiMax
APP1 sensor voltage out of range low, normally set if the
APP1 signal has shorted to ground, circuit has opened or
sensor has failed
642
(68)
APP2AdaptHiMin
Learned full pedal end of APP2 sensor range lower than
expected
652
APP2AdaptLoMax
Learned idle end of APP2 sensor range higher than
expected
662
APP2AdaptLoMin
Learned idle end of APP2 sensor range lower than
expected
632
(67)
APP2RangeHigh
APP2 sensor voltage out of range high, normally set if the
APP2 signal has shorted to power or the ground for the
sensor has opened
622
(66)
APP2RangeLow
APP2 sensor voltage out of range low, normally set if the
APP2 signal has shorted to ground, circuit has opened or
sensor has failed
612
(65)
APP2RangeHigh
APP2 sensor voltage out of range high, normally set if the
APP2 signal has shorted to power or the ground for the
sensor has opened
622
(66)
APP2RangeLow
APP2 sensor voltage out of range low, normally set if the
APP2 signal has shorted to ground, circuit has opened or
sensor has failed
612
(65)
APP_Sensors_Conflict
APP position sensors do no not track well, intermittent
connections to APP or defective pedal assembly
691
(69)