Doosan G424FE - Page 60

G424F(FE) Service Manual Chapter 3. Engine Mechanical System 58
Timing Belt Rear Cover
Removal
Remove or disconnect
1. Timing belt; See “Timing Belt – Removal”, in this
section.
2. Camshaft timing pulley; see “Camshaft Timing
Pulley – Removal”, in this section.
3. Crankshaft timing pulley; see “Crankshaft Timing
Pulley – Removal”, in this section.
4. Timing belt rear cover attaching bolts and nuts,
with a T30 Torx socket wrench; extension and
handle.
5. Timing belt rear cover.
Installation
Install or connect
1. Timing belt rear cover and attaching bolts and
nuts, without tightening.
2. With a T30 Torx wrench, and extension; tighten.
Tighten
• Bolts: 5 – 10 N·m (4 – 7 lb·ft.).
• Nuts: 5 – 10 N·m (4 – 7 lb·ft.).
3. Crankshaft timing pulley; see “Crankshaft Timing
Pulley – Installation”, in this section.
4. Camshaft timing pulley; see “Camshaft Timing
Pulley – Installation”, in this section.
5. Timing belt; see “Timing Belt – Installation”, in this
section.