v. Parameter 17 should always be set to 3 way or 2 way convert since the lb-oz mode
is not an recognized unit within Handbook 44.
vi. Any deviation from the suggested settings may void the approval capabilities of the
scale.
CALIBRATION
Calibration is performed as outlined in Section 7 of this manual. In order to access the
necessary internal push-buttons and the calibration switch, the push-button access cover
and calibration access cover must be removed. After removing the rear cover, follow the
instructions in Section 7 to calibrate the 4100L. If analog calibration is necessary, the rear
cover must be removed to gain access to the zero and span dip switches.
Section 9 Model 4100L
70
To Next Page
Loading...
