EasyManuals Logo

Dorma CS 80 MAGNEO Installation And Maintenance Manual

Dorma CS 80 MAGNEO
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
36 DORMA
15.Daily Safety Checks
The following points have to be observed:
• Aninspectionandacceptancetestaccordingtothebelow-mentionedchecklisthastobe
performed after the first commissioning of the system by trained staff (trained by DORMA).
• Regularmaintenanceandinspectionshavetobeperformed(atleastonceayear)under
consideration of our specifications for the CS 80 MAGNEO by properly trained staff.
•
Accordingtosafetystandards,documentationofthedailysafetycheckshouldbekeptfora
minimum of 1 year.
Checklist (start-up test, maintenance, regular inspections) according to standards.
The system has been installed properly inaccordance with the instructions of the manufac-
turer.
The door panel runs smoothly.
The door works properly (check the opening and closing cycle respectively).
Function if installed activators like radar motion dectectors, pushbuttons or remote controls
has been checked.
The constactless safety equipment (safety sensors), if installed, has been checked for
proper function.
Effective safety equipment if installed to avoid or protect danger spots between certain
parts of the door system and between the door and its structural environment (like for
example safety clearances or the protection of the secondary closing edges).
Test badge has been fixed.
The inspection and maintenance work has been documented.
The CS 80 MAGNEO has to be switched off and secured against unintended and unauthorized
switching on before performing maintenance work (cleaning or maintenance).
Care
Prior to first use and periodically thereafter, but at least once a year, the system must be che-
cked and maintained by a qualified, knowledgeable technician. During the cleaning operation
theProgramSwitchmustbeeitherbeinthe“OFF”orHOLDOPEN”positiontoavoidautomatic
movement of the door. Always disconnect the power before servicing. The entire door (Alumi
-
num, Glass, Stainless Steel) can be cleaned with a moist towel and/or common commercial
cleaners. Any safety sensors are to be cleaned with a dry, soft, non-abrasive towel. The floor and
or threshold (if any) must be kept clean.
Installation and Maintenance Manual
CS 80 MAGNEO

Other manuals for Dorma CS 80 MAGNEO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dorma CS 80 MAGNEO and is the answer not in the manual?

Dorma CS 80 MAGNEO Specifications

General IconGeneral
BrandDorma
ModelCS 80 MAGNEO
CategoryDoor Opening System
LanguageEnglish

Related product manuals