4 DORMA
Dear customer,
We are pleased that a DORMA automatic sliding door has been chosen for this installation.
DORMA carefully designed, tested and built the door of high quality materials as it will provide
many years of service.
Now the door must be installed and adjusted properly to ensure its proper operation and safe
use.
To install and adjust the door for proper and safe operation, the installer must carefully read
this instruction book before proceeding, then follow the instructions exactly.
The door is designed to be installed only by trained and knowledgeable installers.
The installation technician should be experienced in the installation of the automatic entrance
product line.
After installation, the door must be adjusted to confirm with DORMA recommendations and all
code requirements. Be sure to carefully study the requirements in these instructions.
After installation and adjustment, the installer’s final responsibility is to properly instruct the
owner in the safe use of the door. He must also present the owner with the CS 80 MAGNEO
Owner’s Manual and carefully explain how to perform the daily safety check test.
Each step of the installation, adjustment and instructions are important for proper and safe use
of the door being installed. If there are any questions about any items contained in these
instructions, call the DORMA Technical Support Group for assistance.
Yours faithfully,
The DORMA-Team
Required tools:
• Tapemeasure
• Spiritlevel
• Pencil
• ElectricDrill
• MasonrydrillbitØ1/4”
• MetaldrillbitØ1/8”+Ø5/16”
• Socketwrench(10mm)
• Smallflatheadscrewdrivertoconnecttheterminalsonthecontrolunit.
• Phillipsscrewdriverforcountersunkscrewsofwallconnection.
• Allen(Hex)key,4mm
• Combinationwrench,wrenchsize10mmand13mm
• Long-nosedpliersforconnectiontoterminals.
• Adequatescrewsandwallachorsforthestructures,
in case they are not made of brickwork or concrete.
Additionally for DORMA MANET fixing:
• Allen(Hex)key,3mmand5mm
Installation and Maintenance Manual
CS 80 MAGNEO
—