UIC-DX270 Series User’s Manual Rev 1.0
- 38 -
5. INSTALLATION PROCESS
1) INSTALLATION PLACE
Please set this product up in the place mentioning below.
⊙ Low temperature change or normal temperature
⊙ No corrosiveness gas
⊙ No low and high humid
⊙ Low machinery vibration
⊙ Low dirt or smoke
⊙ Low effect from an electrical noise
⊙ No effect from a strong magnetic field
2) INSTALLATION PROCESS
⊙ Set up within a slop of fifteen degrees
⊙ Use a steel plate over 2mm as panel
⊙ Do not set up by force
⊙ Fasten the product with an included screw
3) BE WARNING MATTERS ACID CONNECTION WITH LINES
⊙ Please use the shield cable for between control board and sensor to prevent a noise
⊙ Keep input/output Line away over 30cm from Power Line and do not put same lines together
⊙ Set fuse apart to protect the product from overvoltage
⊙ For a high safety, connect parallel Serge Observer to Magnet Coil
⊙ For a high safety, use noise filter
To Next Page
Loading...