3 External Printer
To watch the instructional video for the installation of the External
Printer, simply use the following QR Code. Or, the instructional video
can also be found at www.YouTube.com by entering the search word
“OPWGlobal”.
An external thermal printer option is available for the SiteSentinel
®
Integra™ console. The printer will be used for printing the various
reports available with the tank gauge system. In order to securely affix
the external printer, use wall-mounting brackets.
1. Using an external wall-mounting bracket, mark the locations
of the screw holes and attach the hanger screws.
2. Next, install the wall-mounting bracket on the external
thermal printer.
3. Remove the side tabs from the external printer to allow for
power cord and USB cord routing.
4. Mount the external thermal printer to the wall by hanging the
printer on the screws.
5. Connect the USB cord from the external thermal printer to
the USB port on the main board located on the inside of the
Integra console.
NOTE: Any available internal USB port may be used for the printer;
however, only the external USB port nearest the wall may be used
for the printer connection.
6. Dress all power and communication cables between the
external printer and the Integra console with cable ties.
7. Plug in the power connector of the external thermal printer.
Figure 3-1 Install Hanger Screws
Figure 3-2 Install Mounting Bracket
To Next Page
Loading...
