Dover OPW SiteSentinel Integra 100 - Density Measurement Sensor (DMS)

Doc. #: M1800, Rev. 06
Page 71 of 101
www.opwglobal.com
Density Measurement Sensor (DMS)
OPW P/N: 30-3232
Density Measurement Sensor
The Density Measurement Sensor (DMS) installs on the pre-existing
probe and continuously measures the average density of the fuel in
the tank. This provides a measure of even the smallest change in
product density within the API density range. Fuel-density reports can
be displayed real-time on the console or exported to an external
device. The readings can be either nominal or temperature-corrected
density.
Density Measurement Sensor
Materials:
Nitrophyl, Delrin, and Stainless-Steel
spring
Resolution:
0.00004 g/cc
Accuracy:
+/- 0.0025 g/cc
Density Range:
0.6 – 1.0 g/cc
Operating
Temperature:
-40°F to 158°F (-40°C to +70°C)
Dimensions:
Length: 11” (27.9 cm), Diameter: 2” (5.1
cm)
Sensors per Barrier:
16 maximum
Suggested Location:
6” (15.2 cm) from bottom of probe)
Note: Use set screw at top and bottom of
sensor to hold in position.