Dover OPW SiteSentinel Integra 100 - OM4 Specifications; OM4 Wiring; OM4 Addressing

Doc. #: M1800, Rev. 06
Page 35 of 101
www.opwglobal.com
6.2 OM4 Specifications
6.3 OM4 Wiring
1. Follow wiring instructions inside the module for proper Petro-
Net communications and power wiring instruction.
2. Connect all relay wiring to the appropriate terminal block(s).
6.4 OM4 Addressing
CAUTION: Do not change the module number while the OM4
module power is ON; in addition, no power can be applied to any of
the relay positions.
When installing two or more OM4 Output Module boxes, place the
address jumpers on the OM4 circuit boards as shown below.
1. Take off the four (4) nuts securing the aluminum cover and
remove it, exposing the circuit board.
2. Set the jumpers.
3. Replace the cover.
Petro-Net
Jumper
Shown on
Address #2
•
•
•
•
•
•
•
•
•
•
•
•
Address #1
Address #2
•
•
•
•
•
•
•
•
•
•
Address #3
Address #4
Not Used
Not Used
Not Used
Not Used
Figure 6-2 OM4 Wiring Connections
Figure 6-3 OM4 Addressing