Instructional Video: “Multi-drop Probe & Sensor Wiring Instructions”
To watch the instructional video “Multi-Drop Probe & Sensor Wiring Instructions” that includes detailed
instructions for Probe Level Indicator (float) installation and the assembly of the epoxy seal packs, use one of
the following:
If you have a smartphone with a QR-code scanner, scan this QR Code
• If you are viewing this manual on a PC or laptop click this link:
Multi-drop Probe and Sensor Wiring Instructions
• The instructional video can also be found at www.YouTube.com by entering the search word
“OPWGlobal.”
Installing the Level Indicator(s)
Figure 9-2 Probe Components
The procedure for assembling the probe level indicators (floats) and probe cable is outlined below.
NOTE: If the wrong type of water level indicator is used, it may float to the top and register an unusually high
water level, not register at all or sink too far and register an unusually low water level. If your product-fluid
density does not fit into one of these groups, contact OPW Fuel Management Systems customer sales
department for recommendations.
To Next Page
Loading...
