Dover Tipper Tie RS4203 - Crimp Control Adjustment

RS4203 Manual Chapter 10 - Clipper and Looper Operation and Adjustments
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 63
10.4 Crimp Control Adjustment
The clips should always form a tight, permanent seal around the product. The tightness or crimp of the
clip can be adjusted by rotating the crimp control adjustment ring.
Before making an adjustment, loosen the crimp control locking knob located at the far side of the support
plate.
Rotate the crimp control adjustment ring clockwise to make a tighter crimp on the product. Rotate the ring
counterclockwise to make a looser crimp.
After the adjustments are complete, retighten the crimp control locking knob.
Crimp control
adjustment ring
Rotate
clockwise
for a tighter
crimp
Clip forming die
Gate
actuator
cylinder
Punch
Cut-off
knife
cylinder