Dover Tipper Tie RS4203 - Control System Configuration

RS4203 Manual Chapter 1 - Machine Description and Specifications
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 15
1.4 Control System
• Operator interface: CTC P1 Touchscreen
Machines built or upgraded after Feb. 21, 2011 will use a CTC PA2 touchscreen.
• PNP proximity sensors
• Programmable Controller (PLC) – source input and source output
• PLC:
o Mitsubishi FX2NC-32MT-DSS – Base Module
o (1) FX2NC-16EX-DS – Extension Module (Input)
o (2) FX2NC-16EYT-DSS – Extension Module (Output)
Machines built or upgraded after Feb. 21, 2011 will use a Mitsubishi FX3UC-32MT/DSS PLC.
Note: The FX2NC input and output modules are compatible with the FX3UC PLC.
Machines built or upgraded after Feb. 21, 2011 will use a CTC PA2 Touchscreen
The illustrations on the next two pages show the machine’s dimensions, layout and major components.