RS4203 Manual Chapter 18 - Assembly Drawings
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 113
Chapter 18 – Assembly Drawings
Important: When ordering parts for optional assemblies or for assemblies with multiple equipment
options (such as rotors and conveyors), refer to the part numbers on the relevant assembly drawing to
ensure you order the correct part for your application and equipment. Options are in Section 18.10.
When ordering replacement or spare parts, always include the following information:
• Machine model number and date of purchase
• Identifying part number that is stamped on the part
• Part number from spare parts list or from assembly drawing
18.1 RS4203 Main Assembly and Clippers
RS4203 RS4203 Assembly
Z4270M Clipper with Stick Clips
Z4270RP Clipper with Reel Pan
00-1568 Knife Cylinder
00-1569 Gate Cylinder
00-1570 Punch Piston
00-1580 Lower Clip Pusher, LH
00-1581 Lower Clip Pusher, RH
00-1582 Upper Clip Pusher, LH
00-1583 Upper Clip Pusher, RH
00-1706 Lower Reel Pan
00-1707 Upper Reel Pan
00-1708 Reel Pan Brake Cylinder
00-1736 Clipper Mount
00-1737 Clipper Rotary Actuator
00-1752 Clipper Swing Yoke
00-1760 Punch Detent Cylinder
00-1807 Remote Stop Switch
00-1916 4 Push Button Remote Station
00-2889 Reel Pan
32-1739 Reel Support Pivot
18.2 Installation Kit and Spare Parts Kits
00-3021 RS4203 & RS4203AB Installation Kit
00-2888 RS4203 Spare Parts Kit
00-4270 Z4270 Spare Parts Kit
18.3 Frame, Base, Air Prep and Valving
00-1728 Frame
00-1745 Base
00-1747 Shutoff/ Quick Exhaust Valve
00-1853 8 Station Valve Manifold
00-2375 Air Manifold Assembly
00-2676 Air Prep
01-0650 Short Leg-Frame
01-0651 Long Leg-Frame
To Next Page
Loading...