Dover Tipper Tie RS4203 - Page 8

RS4203 Manual Publication History
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 8
Revision Description of changes Issue date
20
Revised FRL content and graphics for new modules. Updated ECN
drawings.
January 2, 2008
21
Added water separator to conveyor motor lubricator / water separator
assembly. Updated ECN drawings.
February 2, 2008
22
Revised cleaning sections and deleted cleaning appendix. Revised
clip jam warnings to carefully remove a clip or other obstruction so as
not to damage the parts. Updated ECN drawings.
June 30, 2008
23
Removed drawings 30-1033 thru 30-1037 (on Kim’s approval).
Revised safety and service content. Revised moisture and corrosion
control content. Updated ECN drawings.
October 28, 2008
24
Added water/mist separator retrofit kit assembly drawings (for FRL
00-2746 and conveyor air motor 00-2877) and the alternate water
separator filter element in Spare Parts Lists. Updated ECN drawings.
January 17, 2010
25
Changed cover logo, address/contact box and high air pressure
symbol. Updated ECN drawings.
July 20, 2010
26
Formatted for double-sided printing.
August 11, 2010
27
Replaced corporate logo. Changed proximity sensor maintenance
step to an inspection. Updated ECN drawings.
November 1, 2010
28
In Section 1.4, changed from Mitsubishi FX2N to FX3U PLC and a
PA2 Touchscreen for machines built or upgraded after 2/21/2011.
May 14, 2011
29
Added low voltage and high voltage name plates in Section 1.3 and
edited Specs data. Added replacement PLC battery 30-1259 for
machines built after 2/21/2011. Updated ECN drawings.
September 8, 2011
30
Revised Section 1.3, Name Plate and Specifications. Edited.
Updated ECN drawing.
January 28, 2012
31
Updated Cover Logo. Inserted note about a single schematic having
two versions.
October 6, 2012
32
Checked dimensions. Corrected kg value. Added section(s) on
loading clips.
January 11, 2013