Dover Tipper Tie RS4203 - Page 83

RS4203 Manual Chapter 13 - Cleaning Procedures
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 83
Disassembling the Knife Assembly
Knife cylinder assembly
Knife assembly
Knife block assembly
shown disassembled
for daily cleaning
Warning:
Very sharp
knife edge
M5 x 16 mm long hex head bolt
Knife block
35 degree
angle
Knife
3/32 x 3/4 long
spring pin
(press fit)
M6 x 50 mm long shoulder screw
Male air connector
Knife cover 35 degree angle
Knife assembly
M10 hex nut
Knife assembly
Knife cylinder bracket
Washer plate
6 mm flat washer
6 mm x 20 mm shoulder screw