RS4203 Manual Chapter 14 – Maintenance Guide
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 91
Daily
Voider guide shaft blocks
(1 fitting on each block)
On left: Weekly
Conveyor Idler Roller
(2 fittings - 1 in front and 1 on
back of roller)
Caution: Do not over-grease this
fitting
On right: Daily
Conveyor Shuttle Roller
(1 fitting only)
Weekly
Conveyor Drive Roller Bearing
(2 fittings - one on each side of
roller)
Note: The opposite side fitting is
under the guard)
Caution: Do not over-grease
these fittings
To Next Page
Loading...