104 Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
Getting started
6 Getting started
6.1 Safety instructions
Checking the safety systems
Some safety systems are only checked during start-up. If this check is not
performed regularly, a device malfunction may occur, putting the patient at risk.
► Restart the device at least once per month so that the safety systems will be
checked regularly.
Passwords
If the user password and the service password are not assigned, there is a risk of
unauthorized access to the device settings. As a result, saved device settings can
be changed and not be noticed. The patient may be put at risk. Skip password
assignment only in emergencies.
► Assign the user password and the service password when the device is
switched on for the first time.
6.2 Turning on the device
Prerequisite: The device has been reprocessed as per the reprocessing
instructions and assembled ready for operation (see page 60).
1. Connect the device to the mains power supply.
2. Set the main switch to the position.
WARNING
Risk of device malfunction
Condensed water may form when the device is brought from a cold storage location
into a warm environment.
► To prevent condensation and resulting failures of electrical components, do not
turn on the device after abrupt temperature changes for 1 to 2 hours.
3. Press the key (1).
The device starts. The Standby page is displayed.
If there is sufficient battery charge, the device will also start without the power
plug being plugged in.
4. If necessary, define the required passwords for users and service personnel in
the displayed password dialog.
35026
To Next Page
Loading...
Need help?
General
