Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n 13
Safety-related information
2.9.2 Symbols and product labels
Failure to observe symbols and product labels may result in personal injury and
property damage.
► Observe the symbols and product labels.
2.9.3 Monitoring the patient's condition
Monitoring of a patient's condition can range from direct observation to electronic
monitoring by means of medical devices. The patient may be put at risk if his or her
condition is not adequately monitored.
► Monitor the patient's condition by suitable means and at appropriate intervals.
N
2O, O2, CO2 and, where necessary, anesthetic gases must be monitored when
patients are ventilated. If no monitoring is available or the sensors are not ready for
operation, the patient will not be adequately monitored and may be put at risk.
► Provide for suitable monitoring of O
2, CO2, N2O, and anesthetic gases in
accordance with ISO 80601-2-55.
► Provide for suitable substitute monitoring in the event of a fault.
If substitute monitoring is used, the integrated monitoring may still draw in ambient
air. This may result in lower gas concentrations in the breathing gas than the set
values. As a result, the patient could be put at risk.
► Monitor the patient's condition by suitable means and at appropriate intervals.
► Increase the fresh-gas flow if necessary.
2.9.4 Accessories and components
Compatible accessories
The use of faulty or incompatible accessories may compromise the functional
integrity of the product. Personal injury and property damage may occur as a
consequence.
► Use only compatible accessories. The accessories that are compatible with this
product are listed in the list of accessories supplied with the product.
► Use only accessories that are in good working order.
To Next Page
Loading...
Need help?
General
