Non-invasive blood pressure (NIBP)
300 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Accessing the non-invasive blood pressure settings
1 Select the non-invasive blood pressure
parameter field to select the NIBP page directly.
or
Select Sensor parameters... from the main
menu bar.
2 Select the NIBP tab to access the NIBP page. If
you cannot see the tab, select the following two
symbols located in the upper right corner of the
dialog: symbol and the display filter
button.
The top portion of the page contains the Auto set
and Alarm buttons for configuring the alarm
functions. For detailed alarm setup information, see
"Configuring the alarm settings for a patient" on
page 125
Non-invasive blood pressure parameter setup functions
All non-invasive blood pressure setup functions
take place in the NIBP page (see page 300).
Selection Available settings Description
Interval time [min]
(Cardiac bypass
mode automatically
deactivates interval
measurements)
Off (default), 1 min, 2 min, 2.5 min, 3 min,
5 min, 10 min, 15 min, 20 min, 25 min,
30 min, 45 min, 60 min, 120 min, 240 min
Defines intervals for non-
invasive blood pressure
measurements.
Inflation mode Adult (default), Pediatric, Neonate Sets the threshold for maximum
cuff inflation.
Continuous mode On, Off (default) Initiates successive non-
invasive blood pressure
measurements for 5 min.
Chime On, Off (default) Determines whether or not a
tone sounds at the end of a
completed non-invasive blood
pressure measurement.
Venous stasis On, Off (default) Stops the blood flow to the
lower part of the cuffed limb for
a fixed time.
Color Red, green, blue, yellow, light blue, purple,
orange, white (default).
Determines the color of the
parameter values and labels.
To Next Page
Loading...
