Dräger Infinity C500 - Page 416

External devices – MEDIBUS.X devices
416 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Vent parameter
display
– Auto (default)
– Manual
Determines whether the selected
parameters for display in the
parameter field are selected
manually or automatically. With the
setting Manual, the parameter for
each parameter field location are
selected manually. With the setting
Auto, the parameter supported by
the source device is assigned to
the parameter field location.
Parameter 1 MVe (default), MVi, VTe, VTACH, VTi, RR,
RRf, RRp
Selects the primary parameter in
the ventilation parameter field
when the Vent parameter display
setting is set to Manual.
– MV auto (default) – (available
parameter depends on source
device:MVe, MV, MVi)
– RR auto – (available parameter
depends on source device: RR, RRf,
RRp)
–VT auto – (available parameters
depends on source device: VTe,
VTACH, VTi)
Selects the primary parameter in
the ventilation parameter field
automatically when the Vent
parameter display setting is set to
Auto. The specific parameter
supported by the source device is
assigned automatically according
to the priority list.
Parameter 2 MVe, MVi, VTe, VTACH, VTi, RR (default),
RRf, RRp
Selects the second parameter in
the ventilation parameter field
when the Vent parameter display
setting is set to Manual.
– MV auto – (available parameter
depends on source device:MVe, MV,
MVi)
– RR auto (default) – (available
parameter depends on source device:
RR, RRf, RRp)
–V
T au
to – (available parameters
depends on source device: VTe,
VTACH, VTi)
Selects the primary parameter in
the ventilation parameter field
automatically when the Vent
parameter display setting is set to
Auto. The specific parameter
supported by the source device is
assigned automatically according
to the priority list.
Selection Available settings Description