Dräger Oxylog 3000 plus - Before Reprocessing

Instructions for use Oxylog 3000 plus SW 1.n 121
Reprocessing
Semi-critical
– Breathing valve, breathing hose, flow
measuring lines, angled connector
– Flow sensor
Before reprocessing
Observe before disassembly
1 Turn off the device.
2 Disconnect the plug for the external power
supply.
Patient-specific accessories and consumables
The patient-specific accessories and consumables
must be removed from the device and, if necessary,
disassembled.
Reusable products:
 If the reusable product has its own instructions
for use, perform reprocessing in accordance
with the separate instructions for use.
 If no separate instructions for use are available
for the reusable product, perform reprocessing
in accordance with the instructions in these
instructions for use.
Disposable products:
 Dispose of the disposable products.
Removing the CO
2 sensor and CO2 cuvette
1 Disconnect the CO
2 sensor connector from the
device.
2 Remove the CO
2 sensor (B) from the
CO2 cuvette (C).
3 Remove the CO
2 cuvette (C) from the
flow sensor (D).
4 Remove the angled connector (A)
from the cuvette (C).
052
A
B
C
D