Need help?Do you have a question about the DriSteem Vapor-logic 4 and is the answer not in the manual?
General| Controller Type | Microprocessor-based |
|---|---|
| Power Consumption | 10 VA |
| Enclosure Rating | NEMA 1 |
| Display | LCD |
| Communication | BACnet, Modbus, LonTalk |
| Power | 24 VAC |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Communication Ports | RS-485, Ethernet |
| Analog Outputs | 0-10 VDC or 4-20 mA |
| Analog Inputs | Up to 4 (depending on model), 0-10 VDC or 4-20 mA |
Crucial safety warnings about hot surfaces, energy sources, and electrical hazards.
A checklist of essential steps, wiring considerations, and cable routing guidelines before installation.
Explains how to adjust PID control loop parameters for optimal system response.
Introduces the troubleshooting guide and provides information needed when calling technical support.
Addresses common problems related to power, display, sensors, and control signals.
Details troubleshooting for filling, draining, and heating problems in the system.
Troubleshoots humidity set point issues and gas-to-steam humidifier faults.
To Next Page