OPERATING THE POWERMASTER SYSTEM
D-306232 WP8010/WP8030 V18 DSC EN USER 11
Arming AWAY or HOME „Instant‟
Pressing during the exit delay will arm the system in the "Instant' mode, i.e. without an entry delay.
Therefore, any detection in any zone will trigger an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
PRESENT TAG OR
ENTER CODE _ _ _ _
ARM indicator lights during the armed state.
Forced Arming AWAY or HOME
Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be
bypassed for the duration of arming.
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:
PRESENT TAG OR
ENTER CODE _ _ _ _
[Enter code] /
[Present tag]
(to mute the buzzer)
Vacate the premises
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!
To Next Page
Loading...
Need help?
General
